Ampac FireFinder PLUS Specifications download pdf (Page 31)

Page 25

FIREFINDER PLUS

(

AUST

)

INSTALLATION

COMMISSIONING OPERATION

- Active at access level 2 and 3

This control is used to disable (and enable) the Alarm Devices.

If the indicator is “ON” Steady when any Alarm Devices (including Outputs configured as Alarm

Devices) are disabled and flashes if Alarm devices are in fault. Disable has priority over fault.

- Active at access level 2 and 3

This control is used to disable (and enable) all the ancillary outputs.

The indicator is “ON” Steady when Ancillary outputs are disabled and flashes if Ancillary Outputs have

faults present.

- Active at access 2 and 3 – only when the indicator is flashing.

When the indicator is lit the control is used to override any pre-configured delays to outputs.

The indicator is “ON” Steady when a Delay is programmed and flashes when a Delay Timer is running.

- Active at access level 2 and 3

This control is used to disable (and enable) the external alarm devices output.

If the indicator is “ON” Steady when any Ext Alarm Device output is disabled and flashes if Ext Alarm

device outputs are in fault. Disable has priority over fault.

- Active at access level 2 and 3

The selection keys are used to select a loop device (or range of devices by using

the TO key) or select a zone (or range of zones).

Once a device or zone (or range) has been selected, the DISPLAY or DEVICE

DISABLE/ENABLE controls can be used.

Press this button followed by a number to select the loop you wish to access. e.g.

LOOP 4.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 125 126

No comments

Ampac FireFinder PLUS Specifications Page 31