Ampac FireFinder PLUS Specifications download pdf (Page 101)

Page 95

FIREFINDER PLUS

(

AUST

)

INSTALLATION

COMMISSIONING OPERATION

12.17.3 Printer Connections and Jumpering

Mounted on the back of the printer mechanism is the PCB that carries the;

 Connectors for interconnection to the Main Board,

 Jumper links required to set the programmed print modes; and

 Printer 5 volt DC Power Supply.

Figure 118: PCB Layout

Jumper Settings

Designator Jumper State Function

NOT Inserted Selects ESC Commands

Inserted Selects UP Commands

J2 Set as

Default

NOT Inserted Selects ASCII Character Printing Mode

Inserted Selects Chinese Character Printing Mode

NOT Inserted Select Printing by Contrary Direction

Inserted Select printing in the Normal Direction

J7 Set as

Default

Insert the Shorting Clip Between Pins

1 and 2

Selects the 12 X 12 Font

Insert the Shorting Clip Between Pin 2

and 3

Selects the 15 X 16 Font

12.17.4 Printer 5 Volt Power Supply

27 volts DC is taken from Main Board (BRD86MBA) and fed to CN1 of the 5volt Printer Power Supply

Board. It is this board that drops this voltage from 27volts to 5volts for use by the Printer. Mounted to

rear of printer

Figure 119: Printer Power Supply Board Layout

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 125 126

No comments

Ampac FireFinder PLUS Specifications Page 101