Ampac FireFinder PLUS Specifications download pdf (Page 29)

Page 23

FIREFINDER PLUS

(

AUST

)

INSTALLATION

COMMISSIONING OPERATION

5 FireFinder PLUS Control Panel

Figure 19: The FireFinder PLUS Control Panel

The LCD is used to display abnormal conditions and for interrogation, control and programming

activities. When the FACP is in its normal state a default screen is displayed.

In access level 2 or higher the backlight shall always be ON. Alarm, Fault and Disable information is

accessed through the Main Menu.

Is the intended area for the Alarm Routing Address Code. This area is not printed on

the Decal.

5.1 System Controls

- Active at access level 1, 2 and 3

This control is used to silence the local buzzer. Pressing this button will silence the panel buzzer,

which sounds whenever there is a fire alarm or fault. The sound for a fire alarm is a steady sound

where as for a fault it is intermittent.

- Active at access level 2 and 3.

When the alarm devices are active (FACP is in the fire condition), activating the control will silence all

alarms excluding the External Alarm device.

Activating the control again, will resound the previously silenced alarm devices.

If a new alarm is recognised whilst in the alarm devices are “silenced”, then all alarm devices shall

sound.

Note: If Delays to Outputs have been configured to investigate the delayed Alarm condition press the

“Next” button and “Enter” button.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 125 126

No comments

Ampac FireFinder PLUS Specifications Page 29