Ampac ZoneSense Specifications download pdf (Page 4)

Page 2

ZONESENSE PLUS

OPERATION & PROGRAMMING

1 Introduction

Using 3 levels of access the ZoneSense PLUS Fire Alarm Control Panel ( FACP ) is controlled and

programmed through the keypad on the front panel.

 Note: To assist in the programming process the screens or Menus presented to the operator are

diagrammatically shown as an Appendix at the end of this document.

2 Controls – Front Panel

2.1 System Controls & Indicators

The front panel controls for the ZoneSense PLUS consists of twelve push buttons and an optional

Normal / Enabled key switch.

+ -

RS485

EARTH

DISABLE INPUTS

COM DS MCP FLT

+ Z1 - + Z2 - + Z3 - + Z4 - + Z5 - + Z6 - + Z7 - + Z8 -

DETECTOR ZONES

+ -

EXT BELL

+ -

WARN SYS

+ -

ACF

+ -

ASE

+ -

ALARM

+ -

FAULT

N/O C N/C

ALARM FAULT

N/O C N/C

AUX 24VDC

+ -

RST

/BZ

SYSTEM STATUS

POWER FAULT

POWER

SYSTEM FAULT

EARTH FAULT

ASE STATUS

EXTERNAL

ALARM FAULT

WARNING SYSTEM

FAULT

ACF STATUS

ZONE 1

ZONE 3

ZONE 5

ZONE 7

ZONE 2

ZONE 4

ZONE 6

ZONE 8

ALARM

FAULT / ISOLATE

ACF

ISOLATE

CANCEL

ENTER

AMPAC

MON 07:45

ISOLATE

ACK

RESET

ISOLATE

WARNING

SYSTEM

ALARM FAULT ISOLATED

ISOLATE

EXTERNAL

ALARM

FIREFIGHTER FACILITY

SHD

CONTROLS

NORMAL ENABLED

Figure 1: AS4428 8 Zone Front Panel Controls and Indicators

2.2 Levels Of Access

Access to the FACP is restricted to three levels of authorisation.

 Levels 1 and 2 access is normally restricted by way of keyswitch control;

CONTROLS

NORMAL ENABLED

Controls, Normal – Enabled (Key Switch)

AS4428 requires panel controls to be behind a 003 keyed door or enabled by a 003 key switch.

Operationally the keyswitch is in NORMAL, switching to ENABLED allows access to the controls.

Note: Generally the metal cabinet models are not fitted with a front panel keyswitch as its panel

controls are behind a 003 keyed door.

 Level 3, passwords are entered using the keys on the front panel.

Level 1: ( No Password Required )

By pressing the Menu button access to Level 1 is gained to the read only FAULT, STATUS

display and Password entry menu.

Level 2 ( If set Pre-commissioning Password is factory set at 2222 )

To gain access to the Level 2 TEST and ISOLATE MENUS a fixed 4 digit Level 2 Password or a

key to the control ENABLE switch is required.

1 2 3 4 5 6 7 8 9 ... 28 29

Comments to this Manuals

No comments

Ampac ZoneSense Specifications Page 4

Comments to this Manuals

Related products and manuals for Fire protection Ampac ZoneSense