Ampac FireFinder II Series Specifications download pdf (Page 50)

FIREFINDER NZ

CONFIGURATION MANAGER

5.4 Conventional Modules

Selecting a Conventional Module tab on the Module Data entry Spreadsheet will display the page for

entering the data for that module.

Figure 60: The Conventional Module Settings Page

Circuit: The circuit number is set and cannot be modified.

Zone: The zone number must be a number between 1 and 999.

Description: The description is limited to 33 characters and may contain numbers or characters.

Type: The type of device defaults to normal within the drop down list box.

Type Descr: The type descriptor is automatically entered by the program. This may be modified if

required but it is limited to 6 characters.

Zone Cnfg: The zone configuration column uses a drop down list box to display the options that a

device may be set to; these are Normal, AVF, Self Reset, and Non-latching.

Time Out: This column is the used to enter the time out for the Self Reset configuration. A maximum

of 999 seconds is allowable (60 seconds is considered a norm). An error message will be displayed

if the operator attempts to enter something greater than 999 seconds.

Auxiliary Output: The next column is used to determine if the Alarm LED on the main control panel

is active.

Groups: The next six columns allow the user to enter up to 6 group numbers against each device.

These group numbers are only used for I/O programming.

Map: If a graphical interface is fitted to SmartGraphics this column indicates the Map to which a

particular detector is associated with.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 95 96

No comments

Ampac FireFinder II Series Specifications Page 50