Ampac FireFinder Series II AS442 Specifications download pdf (Page 43)

Page 38

FIREFINDER SERIES II INSTALLATION, COMMISSIONING &

OPERATION

9 Incoming Fire Alarm Signal

 Will operate the red common LED fire indicator

 Will display location of fire alarm origin on the LCD

 Will activate external alarm.

 Will activate the internal FACP buzzer.

 Will activate any ancillary equipment so programmed.

 Will abort any test in progress.

The LCD will always display the first fire alarm signal received in the top section of the LCD. The

lower section of the LCD will also permanently display the most recent zone in alarm. Other essential

fire alarm information and fault or disablement information is available via the

and

keys. After 30 seconds if no key is pressed the top section of the display will revert to displaying the

first zone in alarm.

L1 S1 Z17 ALARM

5/7/2005 15:12:10

SENSOR ALARMS 1 OF 5

DETECTOR 1 SMOKE

Figure 52: LCD Screen with 5 Devices in Alarm

Note: The displayed information changes to that associated with the device as the PREVIOUS /

NEXT push buttons are pressed. If there is a fault condition or a fire alarm and the buzzer is

sounding, press the ACKNOWLEDGE button to stop it sounding

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 113 114

No comments

Ampac FireFinder Series II AS442 Specifications Page 43